Android 4.3 Jelly Bean leaks for Samsung Galaxy S III

Samsung has dedicated to getting Android 4.3 Jelly Bean to the Galaxy S III flagship and also the official rollout should begin in a couple of weeks' time. If you cannot wait for the official release, you should check out the link before to get the beta version.

The beta version is apparently stable enough to operate like a daily driver, even though it could have a bug or two. It brings numerous UI changes, together with a new configurations menu with tabbed interface as available on newer Samsung flagships. The transparent notification bar is here now too.

Regrettably a lot of the icons within this build continue to be while using old design and Samsung Knox isn't enabled. Which should alternation in the ultimate Android 4.3 ROM for that Universe S III, though, which means you don't need to bother about missing around the security feature.

Should you seem like giving the most recent Jelly Bean version an effort run, you need to follow this connect to download the needed files. Should you not know the right path round the Odin flashing software, you will find a step-by-step tutorial in the via link below.

• Model: GT-I9300
• Country: Germany (Vodafone)
• Version: Android 4.3
• Changelist: 1902166
• Build date: Sat, 26 Oct 2013 12:24:03 +0000
• Product Code: VFG
• PDA: I9300XXUGMJ9
• CSC: I9300VFGGMJ5
• MODEM: I9300BUUGMJ3
• Download: I9300XXUGMJ9_I9300VFGGMJ5_I9300BUUGMJ3_VFG.zip

NOTE

• - This firmware will WIPE your device (Perform a backup before flashing)
• - This test firmware will NOT increase your binary counter NOR void your warranty.
• - This test firmware is a pre-release firmware and not official from Samsung.
• - We have fully tested this firmware and this firmware works perfectly as any other official firmware.

INSTRUCTIONS

• - Extract (unzip) the firmware file
• - Download Odin3 v3.09 (From here or here)
• - Extract Odin .ZIP file
• - Open Odin3 v3.09
• - Restart phone in download mode (Press and hold Home + Power + Volume down buttons)
• - Connect phone and wait until you get a blue sign in Odin
• - Add AP_I9300XXUGMJ9_1902166_REV00_user_low_ship.tar.md5 to AP
• - Add BL_I9300XXUGMJ9_1902166_REV00_user_low_ship.tar.md5 to BL
• - Add MODEM_I9300BUUGMJ3_REV02_REV04_CL1413323.tar.md5 to CP
• - Add CSC_VFG_I9300VFGGMJ5_1986192_REV00_user_low_ship.tar.md5 to CSC
• - Make sure re-partition is NOT ticked
• - Click start button, sit back and wait a few minutes.
• - If you encounter any issues with the firmware (Any FC, Bootloop etc)
• - Boot into recovery mode (Home+power+vol up)
• - Choose to wipe/factory reset. (THIS WILL ERASE ALL OF YOUR DATA INCLUDING YOUR INTERNAL SD CARD!)
• - Then choose reboot and you should be good to go!